Nomadic rear rack installation on KTM 690 Enduro R

I finished installing the Nomadic rear rack. The installation was easy, but before you begin make sure you have a big enough drill bit to make the holes on rear fender. The aluminium spacers are 16 mm, but in actuality you need to make 20 mm holes as the holes end up in an angle compared to the spacers.

Installation, how I did it

Remove rear fender 

1. Undo 7 bots, 2 from sides, 2 from top and 3 from under the fender
2. remove fuel cap

3. remove fuel breather hose (just pull on it)
4. lift of fender

Drill holes for bolts on the fender, use dimples under the fender as guide marks
Remove original tank bolts
Reinstall fender, tank cap, and breather hose
Assemble rear rack according to instructions
Insert spacers into holes
Bolt rack into place using bolts provided by Nomadic

The rear fender needs  to be removed. It's held in place by 6 bolts

2 bolts on the sides

2 bolts on the top. Note that the fuel cap and fuel breather hose has to come off too.

Two (of 3) bolts under the fender you need to undo

There are dimple marks for drilling the holes under the fender

The original tank bolts that will be replaced by ones that come with the rack

20 mm hole

the 3 smaller hex bolts will be tightened last

Nomadic rack 6000 kms later

The same one I bought